Close
Mobile phone
  • +41 41 910 41 34

DPA ST4006A

Microphones Set
  • DPA ST4006A
CHF 4444.00
Free delivery in Switzerland
Hand-matched stereo pair omnidirectional condenser microphones.

Description

Even though the standard tolerances on our d:dicate microphones are extremely low, a stereo match is even closer. These specially selected d:dicate 4006A microphones are matched within ±0.5 dB on both frequency response and sensitivity.

The pair comes in a heavy-duty Peli Case for safe transportation and easy access to the microphones and accessories.

The microphone capsule
The MMC4006 Omnidirectional Microphone Capsule offers total transparency in any recording situation. It picks up incredible detail and depth of sound. The definition of its high-frequency characteristics across a wide range of instruments is impressive. It offers natural sound, high sensitivity, low noise-floor and extremely linear frequency response from 10 to 20 kHz (±2 dB).

The d:dicate 4006A Omnidirectional Microphone is a flexible solution. Engineers, broadcasters and musicians alike can achieve clean, natural and precise sound reproduction. This mic is ideal for A-B stereo pairs for symphonic concert hall recordings. It also excels on vocals, for close-miking all types of instruments and as an outdoor interview microphone.

A selection of accessories is available, including acoustic pressure equalizers, a nose cone and interchangeable protection grids. These accessories can acoustically transform the mic. By changing grids, it is possible to gain several unique frequency responses and directional characteristics from the mic. Furthermore, these accessories will not produce any phase shift, noise or distortion that would otherwise be introduced by an electrical filter.

A truly flexible range
The d:dicate 4006A Omnidirectional Microphone is part of the flexible d:dicate Microphones Series. It combines the MMC4006 Omnidirectional Capsule with the MMP-A preamplifier. This combination is for the true audiophile. It offers low distortion and totally accurate and faithful sound.

Another option, the d:dicate 4006C Omnidirectional Microphone, Compact offers a subtle character alteration with a bit more "body" to the low end than the d:dicate 4006A Omnidirectional Microphone.

At any time, and with no tools needed, it is possible to transform the d:dicate 4006A Omnidirectional Microphone into a new configuration. You can combine it with another d:dicate or d:facto Microphone Capsule or Preamplifier.

The d:dicate 4006A Omnidirectional Microphone is also available individually.

Features
The product offers the following features
Carefully matched microphones
Natural sound
High sensitivity
Low noise-floor
Extremely linear frequency
Sturdy Peli Case for transportation and protection

Supplied items

2x 4009A Omnidirectional Microphone
2x Clip for d:dicate
2x foam windscreen length 56mm
2x free-field grid for d:dicate 4006
2x close-miking grid, trapizoid, silver
2x diffuse-field grid for d:dicate 4003 and 4006
1x Peli case for d:dicate microphones

Attributes

Product Details
Product Number 190474
Brand DPA
Series d:dicate
Category Microphones Set
Brand Category DPA - Mic Sets
Relevancy rank 14 of 35
Date January 2020

Properties

- Directional pattern
- Omnidirectional
- Principle of operation
- Pressure
- Cartridge type
- Pre-polarized condenser
- Frequency range
- 10 Hz - 20 kHz
- Frequency range, ±2 dB
- 10 Hz - 20 kHz
- Sensitivity, nominal, ±2 dB at 250 Hz
- 40 mV/Pa; -28 dB re. 1 V/Pa
- Equivalent noise level, A-weighted
- Typ. 15 dB(A) re. 20 µPa (max. 17 dB(A))
- Equivalent noise level, ITU-R BS.468-4
- Typ. 27 dB (max. 29 dB)
- S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL)
- Typ. 79 dB(A)
- Total harmonic distortion (THD)
- < 1% up to 139 dB SPL peak
- Dynamic range
- Typ. 124 dB
- Max. SPL, peak before clipping
- 146 dB
- Switchable attenuator, filters etc.
- 0 dB / -20 dB
- Output impedance
- 200 [Ohm]
- Minimum load impedance
- 2 k[Ohm]
- Cable drive capability
- 100 m (328 ft)
- Output balance principle
- Impedance balancing with Active Drive
- Common mode rejection ratio (CMRR)
- > 60 dB
- Power supply (for full performance)
- 48 V Phantom power (± 4 V)
- Current consumption
- 2.8 mA
- Connector
- XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
- Color
- Matte black
- Weight
- 163 g (5.7 oz)
- Microphone diameter
- 16 - 19 mm (0.6 - 0.75 in)
- Capsule diameter
- 16 mm (0.6 in)
- Microphone length
- 170 mm (6.7 in)
- Maximum output voltage, RMS
- 8 V
- Polarity
- +V at pin 2 for positive sound pressure
- Temperature range
- 40°C to 45°C (-40°F to 113°F)
- Relative humidity (RH)
- Up to 90%

Brand

Unparalleled accuracy Close your eyes and listen. From the subtlest nuances of a solo violin or vocalist to the thunderous intensity of a full brass section or drum kit, it's all there, spectacularly pure and uncolored. The sound is so crisp and detailed that you begin to create a mental picture of what the recording environment looked like. The microphones responsible? DPA, of course. From B&K to DPA Although DPA has technically only been in existence since 1992, our company draws on more than five decades of world-class microphone design experience going back to the first range of measurement microphones created by our progenitor, Brüel & Kjær, in the 1950s. Rapid growth and rabid fans Over the past 16 years, we have expanded from a tiny initial staff of only two people to well over 100 and are now represented by professional audio distributors and dealers in more than 40 countries around the world. In the past five years alone, we have experienced an average annual growth of 25 percent, and, in 2007, were presented with the prestigious King Frederik IX's award for outstanding contribution to Danish export. What's our secret? The reason for our success is simple: DPA's ultimate goal is to provide you - whether you're in live sound, recording, theater or broadcast - with the absolute finest possible microphone solutions for your tasks. We take no shortcuts in our design processes nor make any compromises in our manufacturing, which is all done in Denmark. As a result, our products are globally praised for their exceptional clarity and transparency, superb specifications, supreme reliability and, above all, pure, uncolored and undistorted sound.
Report incorrect data about this product
Quantity:-+
Why MusiX?
  • Free delivery in Switzerland from CHF 50.-
  • 3 Year Warranty in Switzerland
  • 25,000 products in stock
  • Payment After Delivery Or By Installment
  • Daily deliveries
Your Settings
Discount base: 1. Previous MusiX price, 2. Recommended list price
MusiX chatHave a question?[[missing key: down arrow]]
Press Enter to send
MusiX chat