Skip to main contentSkip to navigationSkip to search

Free The Tone Red Jasper RJ-2V Overdrive

Free The Tone
CHF 259.75
CHF 262.90
1 unit in stock
Ships immediately from our stock (CH)
Free delivery in Switzerland
Rebirth of “RED JASPER” low gain drive pedal that stimulates player’s mind

The RJ-1V RED JASPER won popularity as FREE THE TONE’s first low gain drive pedal but was discontinued in 2018 because some of its component parts became difficult to obtain. Now, after three years the RED JASPER has come back. Again the RED JASPER “RJ-2V” features a sound resembling that of vintage tube amps, namely, smooth highs, punchy mids, full but tight lows, and natural and pleasing compression feel. We carefully examined and selected every component to refine the sound of this product. In general the sonic output of an overdrive unit in the lower registers varies with its gain setting and the type of guitar or amp/cabinet used. There would be many occasions where you wish to correct an excess or deficiency of the lower register components. The RJ-2V newly adds a mode switch to select from four modes of different low frequency characteristics (cut-off frequencies). With this you can adjust the lower register output to suit the characteristics of your guitar/amplifier. In addition the RED JASPER has a HI-CUT tone circuit to adjust higher registers. We adopted a passive circuit with minimum phase error in the guitar signal to attain high-fidelity amplification, to get natural tone, and to keep guitar’s original timbre. This circuit provides a natural change like the tone control on a guitar and turning the knob counterclockwise cuts highs gently. From a subtle whispering tone to a powerful and persistent drive sound, it can output your guitar sound expressively. Try the RED JASPER, our newly reborn drive pedal.
Mode selector switch setting

Mode selector switch setting

The low end of the bass range is gradually cut from setting A to setting D. Setting A SW1: ON / SW2: ON Setting B SW1: ON / SW2: OFF Setting C SW1: OFF / SW2: ON (* Left figure: Factory default setting) Setting D SW1: OFF / SW2: OFF

  • - Carefully chosen high reliability components.
  • - Passive type tone circuit (hi-cut) to minimize phase error in guitar signal.
  • - Mode switch to select low end frequency characteristics from four settings.
  • - Astoundingly excellent signal-to-noise ratio.
  • - FREE THE TONE’s original HTS (Holistic Tonal Solution) circuit is implemented. Unlike conventional buffer circuits, the HTS circuit attains both “sound” and “low noise” by performing impedance conversion while fully bringing out sound characteristics of the guitar. The HTS circuit prevents degradation of guitar timbre even when the effect is turned off.
  • - There is no need to worry about phase reversal: the output signal is in the same phase as the input signal.

- Input impedance: min. 390 kΩ
- Output load impedance: min. 10 kΩ
- Controls: LEVEL, HI-CUT, and DRIVE knobs
- Terminals: 2 x 1/4" standard phone jacks (input, output), DC9V input jack (for AC adapter connection)
- Power supply: 9-volt PP3 battery, AC adapter
- Current consumption: 11 mA (DC 9 V)
- Dimensions (D x W H): 123 x 100 x 53 mm (incl. protuberances such as footswitches, jacks, etc.)
- Weight: approx. 320 g (excl. battery)

Key attributes
Effect Types
Overdrive
Battery Operated
Yes
True Bypass
No
Distortion Pedal attributes
PSU Included
No
Mini Form
No
Input Configuration
Mono
Output Configuration
Mono
Voltage
9V
Analog/Digital
Analog
Product Details
Product Number
236861
Brand
Free The Tone
Series
Standard Series
Category
Distortion Pedal
Brand Category
Free The Tone - Distortion
Relevancy rank in Category Distortion Pedal
229 of 631
Date
May 2022
Related Products