Temple Audio Design 4 Channel Buffer Module / 4X Mod Pro V2

The 4X MOD Pro V2 mounts in the Modular Endpanel of your Templeboard and allows you to route 1⁄4” inputs and outputs through the side of your board. INPUT/OUTPUT JACKS The 4X MOD Pro features two buffered inputs and two buffered outputs. Whatever 1⁄4” signal you send into one jack will carry on to the corresponding jack on the other side. LOOP A INPUT - Buffered input. Plug guitar in here.* LOOP A OUTPUT - Buffered output. Out to front of amp.* LOOP B INPUT- Buffered input. Input from amp’s FX loop send.* LOOP B OUTPUT - Buffered output. Output to amp’s FX loop return.* *This is the recommended configuration for the 4-cable method, but the 4X Pro V2 can be used for any setup requiring 2 inputs and 2 outputs. SWITCHES: 1. Engage/disengage buffer on LOOP A INPUT 2. Engage/disengage buffer on LOOP A OUTPUT 3. Engage/disengage buffer on LOOP B INPUT 4. Engage/disengage buffer on LOOP B OUTPUT 5. Engage/disengage AUTO LOOP AUTO LOOP allows you to quickly switch between rigs with or without FX loops. If no cables are present in the LOOP B jacks, your FX loop pedals are automatically re-routed to LOOP A OUTPUT (after your drive pedals and before the amp). CONFIGURATION OPTIONS The 4X MOD Pro is an excellent choice for setups that use the Four Cable Method. This setup lets you place some of your pedals (I.e. compressors, overdrives) before your amplifier’s preamp/EQ section and the rest of your pedals (i.e. reverbs, delays) in the FX loop after the preamp/EQ section.